The Omnipod® 5 allows users to select from two modes of insulin delivery: Automated mode and Manual mode. Automated mode uses the CGM values and trends to make an insulin dose adjustment every 5 minutes using a customized glucose target. The customized glucose target will display as the BG target line on the Glooko reports. In Manual Mode, the System delivers insulin using a programmed basal rate.
Viewing the system details of your Omnipod® 5 on your Glooko reports provides an overview of what modes were responsible for insulin delivery from your Omnipod® 5 over the time range selected. To learn more about the Omnipod® 5 modes and the Omnipod® 5 system, including when the device will be available for you, please visit Insulet’s Omnipod® 5 FAQs.
The system details from your Omnipod® 5 may be viewed in the following places:
Summary
On the Summary page, the System Details widget on the right-hand side of your screen will display information from your Omnipod® 5 when either BG or CGM is selected as your data source.
Overview Report
To view the Overview report:
- Select Graphs
- Select the Overview tab
In order to see the system details on your Overview report, ensure the time frame is set to 1 day.
Below the glucose, carbs, and insulin details, you will find the system details section which displays the modes active for insulin delivery from the Omnipod® 5.
NOTE: While in Automated Mode, your basal modulation line will not display in the basal row.
The system details summary will also display below the graph on the 1-day Overview:
Daily Overview (PDF-only)
To create the Daily Overview report:
- Select Create PDF Report
- Select the date range for the report from the Create PDF pop up
- Select Daily Overview
- Select Create PDF
The system details display on the graph, beneath the Glucose, Carbs, and Insulin data for each day’s graph.
Similarly, a comparative summary chart of the system details can be found on the bottom right of the PDF. This will display the system details for the day alongside the system details from the selected time frame. While Automated Mode and Manual settings are separate modes on the pump, the Automated: Activity and Automated: Limited are sub-modes of Automated Mode.
Note: If the Omnipod® 5 loses connection to the CGM device while in Automated mode, the pump will enter Automated: Limited mode. While this mode is active, you may not see corresponding CGM BG readings on your graph.
Week View (PDF-only)
To create the Week View report:
- Select Create PDF Report
- Select the date range for the report from the Create PDF pop up
- Select Week View
- Select Create PDF
The system details display on the graph, beneath the Glucose, Carbs, and Insulin data for each day’s consolidated graph.
