Having the wrong time or date on your original CareSens N/N POP can cause issues when trying to sync with Glooko. By following a few easy steps, you can make sure your data is there when you expect it to be.
In order to change the date and time on your original CareSens N/N POP meter, simply follow the below instructions.
Enter into Setting Mode
Press and hold the S button for 3 seconds to switch on the meter. After all settings are finished, press and hold the S button for 3 seconds to turn off the meter. Press ⬆ or⬇ to reach the accurate value. Press and hold ⬇ to scroll faster.
Adjust the Date and Time
Step 1: Entering the SET Mode
- Press and hold the S button for 3 seconds to switch on the meter. After all the segments flash across the screen, the SET character will be displayed on the screen.
- Press the S button again to progress onto the next step.
Step 2: Setting the Year
- Press and release⬆ or⬇ to adjust until the correct year appears.
- Press and hold the ⬇ button to scroll through the numbers quickly.
- After setting the year, press the S button to confirm your selection and progress onto the next step.
Step 3: Setting the Month
- A number indicating the month will be blinking on the left corner of the screen.
- Press⬆ or⬇ until the correct month appears.
- Press the S button to confirm your selection and progress onto the next step.
Step 4: Setting the Date
- Press⬆ or⬇ until the screen displays the correct date.
- Press the S button to confirm the date and progress onto the next step.
Step 5: Setting the Time
The meter can be set in the AM/PM 12-hour or the 24-hour clock format.
- Press⬆ or⬇ to select a format. The AM • PM symbol is not displayed in the 24-hour format.
- After selecting the format, press the S button to progress onto the next step.
Step 6: Setting the Hour
- Press⬆ or⬇ until the correct hour appears.
- After the hour is set, press the S button to progress onto the next step.
Step 7: Setting the Minute
- Press⬆ or⬇ until the correct minute appears.
- After setting the minute, leave setup mode by pressing and holding the S button for three seconds.
- The Time and Date setting mode will finish and the meter will be turned off.